ZMIN barcode printer built-in wireless network card (WiFi) setup and usage instructions I. Set the printer to AP (server) mode With the printer powered off, set DIP switch 6 to the down position (as shown below), then power on; after startup, the printer is in AP (server) mode. Note: A WiFi printer takes about 30 seconds to start. During startup, the paper and ribbon indicators flash simultaneously and the ready indicator stays on; after startup, all 3 indicators stay on (in thermal mode, two indicators stay on and the ribbon indicator is off). In server mode, the printer acts like a router and can be discovered by WLAN; the printer name usually starts with "ZMPrinter". After connecting to the printer, the terminal is automatically assigned an IP, starting from 10.10.100.100. In server mode, the printer's IP address is fixed at 10.10.100.180. II. Set the printer to STA (client) mode With the printer powered off, set DIP switch 6 to the up position, then power on; after startup, the printer is in STA (client) mode. In client mode, the printer needs to join an existing local network and acts like a computer, so an IP needs to be set. DIP switch settings: 1 Down: ribbon sensor off (print thermal paper) 2 Down: tear-off mode enabled (feed paper to the tear bar after printing) 3 Down: cutter enabled (cutter optional) 4 Down: peeler enabled (peeler optional) 5 Down: transmissive sensor enabled; Up: reflective sensor enabled 6 Down: WiFi server mode; Up: client mode 7, 8 Set the serial communication baud rate (used for serial communication)
Download the PDF document: /\upload\WiFi_X.pdf
