For illustrated setup instructions, please click here
ZMIN X Series Barcode Printer
Network Print Server Setup Instructions
Equipment required: ZMIN barcode printer, USB print server
Obtain the print server's IP address: find a router (one that can automatically assign IP addresses), connect the print server with a network cable first, then plug in the power. The print server can then obtain an IP address assigned by the router. To find out this IP address, log in to your router and check it.
In the figure above, the client named Unknown is the print server. The IP address is for reference only and differs from the one used in the settings below.
Add a network printer and install the driver
1. Connect the printer, go to Control Panel -> Fax and Print Services, and select Add Printer.
2. Click Next directly.
3. Select the local printer attached to this computer. Do not select automatic detection. Then click Next.
4. Select Create a new port, Standard TCI/IP Port, and click Next.
5. Enter the printer name or IP address, which is the print server's address.
6. Select Custom and enter the configuration
7. Here mainly set the protocol, LPR settings
8. After clicking OK, the setup is complete. Then just install the printer driver.
After installation, print, and you are done.
If you have any questions about use, please contact Email: support@zmin.com.cn